Home > Blog

How to efficiently clean metal hydraulic balers

metal scrap balers are easy to move, easy to operate, easy to maintain, reliable in sealing, and do not need foot screws during installation. Users can customize packaging specifications and sizes according to their needs to maximize transportation or storage. It is a good equipment to improve labor efficiency, reduce labor intensity, save manpower and reduce transportation costs.

Metal hydraulic baler cleaning process:

1. String the packing rope of the hydraulic baler through the automatic elastic tightening device behind the garbage compactor, and place it along the packing belt groove, then tie the packing belt to the pull station at the bottom of the packing groove, and rotate the automatic elastic tightening device 90 degrees , open the bottom door and lock it;
2. Put the recycled waste paper, plastic, and film residue into the hydraulic baler. When the material is loaded to the height of the platen, close the door tightly and press the "press down" button. The equipment runs automatically and compacts. (The feeding height of materials other than cardboard can only be slightly higher than the bottom door);
3. The pressure plate moves downward and compresses to reach the maximum pressure, and then automatically returns to the fully open position. When tightening and packing constraints, the platen stops at the preset position of the compressed material;


4. Open the equipment door and pass the binding rope from front to back through the bottom wire slot and back to the front through the pressure plate wire slot, and tighten the binding rope by hand. Push the packing rod by hand, push the rod to a fixed position, and lock it tightly. Press the "up" button, and the return stroke of the oil cylinder will automatically pull out the bundled bundles. (When opening the lower door, no one is allowed to stand in front of the door, so as to avoid accidental injury when the door bounces open);
5. After the bale pops up, reset the baling lever to stop the downward action. Finally, remove the bundled waste paper and plastic waste before stacking and storing, close the door and lock it to enter the next packaging cycle task。